Give Your Cell Cultures a Multi-layered Defense Against Contamination

The In-Vitrocell direct heat CO₂ incubator offers both complete control of the chamber atmosphere and control of contamination to microbiological cell culture laboratories. 

The best defenses are layered. The In-Vitrocell combines layers such as smooth chamber construction and constant HEPA filtration as defensive lines against contamination. A choice of high heat or humidified decontamination on most In-Vitrocell models provides redundant protection against contamination of your cell culture. 

Stainless Steel Chamber. The incubator chamber is a smooth, coved corner stainless steel design to make wipe down as easy as possible. Filters are located outside the chamber and further help create an easy to clean interior. 

Closed Loop HEPA Filtration. An air pump circulates existing chamber air through a HEPA filter for constant protection. The In-Vitrocell direct heat incubator routes fresh air and gas through disk filters on the front and constantly recirculates existing chamber air through a separate bay located under the chamber where a HEPA filter cleans it, and gas sensors measure its CO₂ and O₂ levels. The air is returned to the chamber after passing through a humidity reservoir if more humidity is needed. 

High Heat Decontamination. A 145C cycle can be run in only 8 hours while leaving filter and most sensors installed (the RH sensor must be removed for decontamination). 

Click here to learn more or request your quote today.